MyRevest logo next to a professional who is applying varnish with a roller
MyRevest logo next to a professional who is applying varnish with a roller

MONOCOMPONENT WATER-BASED ACRYLIC VARNISH
MYSEALANT POOL

Liquid preparation of MySealant 2K sealing varnish

MySealant Pool is a water-based monocomponent acrylic varnish made up of copolymers suitable for use in the vessel, the edges or rim of any swimming pool.

This is because thanks to its composition, it increases both the mechanical and chemical resistances of the areas where it is applied. Thanks to its permeability, it also protects them from water vapor and from alkali.

This product can be applied in micro-cement pools of both fresh and salt water, providing a protective film that will help to preserve them in the best conditions indefinitely.

Technical Characteristics of the water-based monocomponent acrylic varnish

Solids
15-20%

pH
6.5 - 7.5

Viscosity (Ford Cup 4)
10-15 sec

Density 20ºC
1 ± 0.01 g/mL

Application temperature
10°C - 25ºC

Dry to touch
20 min

Performance of the water-based monocomponent acrylic varnish

MySealant GO!

0.12 L/m² - (for 2 layers)

Container of single-component water-based acrylic varnish MySealant Pool

Methods of applying the monocomponent water-based acrylic varnish

Before applying MySealant Pool it will be essential to check that the support is in an optimal state, that is, dry and dust-free.

It is also necessary to consider the weather conditions and the ventilation level of the area where the surfaces to be sealed are located.

Before applying MySealant Pool sealer 24 hours must pass, at least, after the application of the last layer of finishing microcement.

This primer is applied in two hands. For a correct application, it is advisable to use a short hair microfiber roller. Leave between 4 and 8 hours between layers.

If it rains during the first 7 days after applying the sealer on the area in question, it will have to be dried and then sanded and varnished again.