MySealant Pool is a single-component water-based acrylic varnish made up of copolymers ideal for use in the body, edges or crown of any pool.
This is because, thanks to its composition, it increases both the mechanical and chemical resistances of the areas on which it is used. Thanks to its permeability, it also protects them from water vapor and alkali.
This product can be applied in microcement pools of both fresh and salt water, providing both a protective film that will help to preserve them in the best conditions for an unlimited time.
Solids
15-20%
pH
6.5 - 7.5
Viscosity (Ford Cup 4)
10-15 seg
Density 20ºC
1 ± 0.01 g/mL
Application Temperature
10°C - 25ºC
Touch dry
20 min
MySealant GO!
0.12 L/m² - (for 2 layers)
Before applying MySealant Pool it will be essential to check that the support is in an optimal state, that is, dry and dust-free.
It is also necessary to consider the weather conditions and the level of ventilation in the area where the surfaces to be sealed are located.
Before applying the MySealant Pool sealant, 24 hours must pass, at least, after the application of the last layer of finishing micro cement.
This primer is applied in two coats. For correct application, it is advisable to use a short-hair microfiber roller. Leave between 4 and 8 hours between coats.
If it rains on the area in question in the first 7 days after applying the sealant, it will be necessary to let it dry and then sand and varnish it again.